Blackstar LT-BOOST Manuel d'utilisateur télécharger pdf (Page 3)

Controls

1. Bass

The tone circuit on the LT BOOST is known as a ‘cut and boost’

circuit. As the name suggests this allows a range of frequencies to be

reduced (i.e. cut) or increased (i.e. boosted). The bass control adjusts

the amount of cut or boost that will be applied to the bass frequencies

of your tone. In the ‘12 o’clock position’ the amount of bass is neither

cut nor boosted. Turn the control left to cut the amount of bass, or

right to increase the amount of bass.

2. Treble

Similarly, the treble control adjusts the amount of cut or boost that will

be applied to the treble frequencies of your tone. In the ‘12 o’clock

position’ the amount of treble is neither cut nor boosted. Turn the

control left to cut the amount of treble, or right to increase the amount

of treble.

3. Gain

The Gain knob controls the amount of gain boost that is applied to the

guitar signal. At low levels, a boosted clean sound will be achieved

and your amp will sound more dynamic and full. As the Gain control

is increased the amplier will start to overdrive and the resulting

distortion will be rich in harmonics and compression.

4. Effect On/Off Switch

Press this switch to turn the effect on or off.

5. Effect On/Off LED

When the LED is on the pedal is on. When the LED is not on the

pedal is off.

6. Input

Plug your guitar in here. Always use a good quality screened guitar

lead. To maximise battery life unplug your cable from the pedal when

not in use.

7. Output

This output is designed to be connected either directly to the input

of your amplier or to the input of another pedal in your signal chain.

Always use a good quality screened guitar lead.

8. DC Inlet

For the input of a 9V DC adapter. Always use a Blackstar approved

9V adapter.

9. Battery Compartment

Insert a 9V PP3 battery here. When the Effect On/Off LED begins to

glow less brightly you should change the battery.

English

1 2 3 4 5 6 7 8 ... 15 16

Pas de commentaire

Blackstar LT-BOOST Manuel d'utilisateur Page 3